TECNA TE1700 - Page 63

TECNA WELD TESTER TE1700
2  FORCE CONFIG MENU: For setting the force rate LOW, MID or
HIGH (i.e. 240 daN, 480 daN or 1,200 daN).
3  PRE BLANK CONFIG: For setting the PRE BLANK time in
milliseconds. Between 0 and 200 ms.
4  POST BLANK CONFIG: For setting the POST BLANK time in
milliseconds. Between 0 and 200 ms.
5  PULSE NUMBER CONFIG: For setting the number of pulses.
Between 1 and 9.
6  FORCE FILTER: Activates\Deactivates the filter on the force
measurement signal.
7  TRIGGER LEVEL: For setting the trigger level on the signal.
8  CONTINUOUS MODE: For selecting the type of signal acquisition
NORMAL\CONTINUOUS.
L  LIMIT CONFIG: For accessing the submenu for setting
measurement check limits.
PAGE 63