TECNOMOTOR 810 - Technical Specifications

50
WARNING!
Never use compressed air on the analyser fittings to clean
the internal pneumatic components, as the pressure
applied to the internal circuit may cause the pneumatic
circuit to break.
The emission analysis of 2 and 4-stroke vehicles will cause the filtering system
to become dirtier than during the analysis of the vehicles. For this reason, it is
recommended:
o to replace worn filters.
o to clean the sampling probes with compressed air at regular intervals.
9 Technical Specifications
23 x 34 x 22.5 cm
(with internal battery) less than 15 Kg
1.126 Kg
220/110 V - 50/60 Hz 30 W
5° ÷ 40°C
-20 ÷ 60°C
850 hPa ÷ 1025 hPa
0% RH ÷ 95% RH
3 min.
Electronic and automatic through solenoid valve
0 ÷ 150°C Res. 1°C
0 ÷ 10% Vol. Res. 0.01% Vol.
0 ÷ 20% Vol. Res. 0.1% Vol.
0 ÷ 20000 ppm Vol. (optional) Res. 1 ppm Vol.
0 ÷ 21% Vol. Res. 0.01% Vol.
0 ÷ 2 Res. 0.001
0 ÷ 5000 ppm Vol. (optional) Res. 1 ppm Vol.
less than 15 Kg