11
3.3 Analyser configuration
Access the configuration menu when you want to make some setting changes
(change date and time) and every time you change the configuration used (e.g.
if you switch from the inductive clamp revolution counter to the M.C.T.C.NET
revolution counter).
3.3.1 Setting workshop data
During the initial message when the instrument is switched on, press the F
key, or press "ESC" twice if you are on the test type selection page. The menu
shown in the figure below will appear.
►Setup
Service
Select Setup and press the confirmation key ( ).
Select "Workshop data", and press the confirmation key
Select the workshop related items, and select them by
pressing the confirmation button ( ).
3.3.2 Setting time and date
During the displaying of the initial message when the instrument is switched on,
press the ESC key or the F function key, or from the main menu of the
instrument press the ESC key twice.
Select Setup and press the confirmation key ( ).
Select "Time and Date", and press the confirmation key
To change the time select “Time”, and press the
To Next Page
Loading...
