14 INSTALLATION INSTRUCTIONS
RECEIPT OF UPS
Inspect the UPS upon receipt. If the UPS has been damaged during shipment, keep the box and
packing material for the carrier. Notify the carrier and dealer immediately. Make sure the
following is in the box
• EVO UPS
• UPS output cable
• AC input power cord
• Phone cable
• User’s manual
• UPSILON 2000 software for UPS management (including CD-rom and RS-232 cable)
• User’s manual
We advise you to keep the original box in a safe place and use it in case the UPS needs to be
sent to the service for maintenance.
PLACEMENT
We advise you to place the EVO as close as possible to the AC input line and to the equipment
that needs to be powered. The UPS is designed to operate in protected environments (for
example: offices).
This UPS should be installed indoors with adequate airflow and free of contamination. Locate it
in a clean and indoor environment, free from moisture, flammable liquids, and direct sunlight.
In all circumstances, see the TECHNICAL CHARACTERISTICS chapter for environmental
specifications and check that the selected area meets these criteria.
EVO requires at least 20 cm of unobstructed space all around in order to be properly ventilated.
Do not obstruct ventilation holes and do not insert objects or liquids in the ventilation holes.
Do not place any object on top of the EVO UPS. Do not pour liquids, flammable gases, or
corrosive substances near or on the unit.
UPS EVO 12 User’s manual
To Next Page
Loading...
