TECO A510s Series - Chapter 10 Troubleshooting and Fault Diagnostics

9
Chapter 3 Parameters
Parameter group Group Name
Group 00
Basic Parameters
Group 01
V/F Control Parameters
Group 02
IM Motor Parameters
Group 03
External Digital Input and Output Parameters
Group 04
External Analog Input and Output Parameters
Group 05
Multi-Speed Parameters
Group 06
Automatic Program Operation Parameters
Group 07
Start /Stop Parameters
Group 08
Protection Parameters
Group 09
Communication Parameters
Group 10
PID Parameters
Group 11
Auxiliary Parameters
Group 12
Monitoring Parameters
Group 13
Maintenance Parameters
Group 14
PLC Parameters
Group 15
PLC Monitoring Parameters
Group 16
LCD Parameters
Group 17
Automatic Tuning Parameters
Group 18
Slip Compensation Parameters
Group 19
Wobble Frequency Parameters
Group 20
Speed Control Parameters
Group 21
Torque And Position Control Parameters
Group 22
PM Motor Parameters
Parameter Attribute
*1
Parameters can be changed during run
operation.
Note1: New added or modified parameters in
software V1.02
Note2: New added or modified parameters in
software V1.10
Note3: New added or modified parameters in
software V1.20
Note4: New added or modified parameters in
software V1.30
Note5: New added or displayed parameters in
software V1.30, when 00-32=8
*2
Reserved
*3
Parameter will not reset to default during a
factory reset (initialization).
*4
Read-only parameter
*5
Parameter will be displayed in being
coupled with the option card.
*6
Parameter will be displayed only in LED
keypad.
*7
Parameter will be displayed only in LCD
keypad.
*8
When 13-08 setting is changed, the value
will be also changed.