Din Rail Mounting Diagram
DIN Rail Installation
A mounting clamp and a 1.38”width rail must be used to install the drive on the rail.
34
FLUXMASTER 50 INSTRUCTION MANUAL
Step 1 -
Aim and insert the 4
retention ribs of the DIN
rail at the 4 holes in rear
panel of AC drive
Step 2 -
Push the DIN rail
forward until the middle
rib grips firmly with
back panel
Step1-
Use a small screwdriver,
inserting it into the
middle rib of DIN rail
and press the screwdriver
in order to remove the
DIN rail from the AC drive
1. Pull the mounting plate downward.
2. Rotate the inverter module to dismount it.
First place the groove on the back of module on
the upper edge of din rail, then push the module
down to lock-up position.Finally press the mount-
ing plate upward into module.
To Next Page
Loading...
