When ticked, the user category activates when a user with the appropriate alarm
group enters their PIN or badges their card.
Areas
An alarm control level can only control the functions of areas that are assigned to
it. An alarm control level can be linked to multiple areas. For each area, the alarm
control level can control the area’s permissions for arming, disarming, alarm
reset, and for timing.
Click the Assign button to open a dialog to assign areas to the alarm control
level. In the dialog, move the required areas from the Available areas list to the
Assigned areas list using the button. Areas can be removed from the
Assigned areas list using the button. Click the OK button when finished.
Note: In IP Extended mode, the NAC is programmed via the USB/IP connection.
Thus CTPlus does not have information about which areas are programmed on
the ChallengerPlus panel that the NAC is connected to. Therefore, the Available
areas list will contain all 99 theoretically available areas on a ChallengerPlus
panel, and will not show the names of the areas. You must match the area
numbers to assign to the alarm control level with the area numbers required for
alarm control on the ChallengerPlus panel.
The following permissions for each area can be changed:
Arm – A user with the appropriate alarm group can arm the area.
Disarm – A user with the appropriate alarm group can disarm the area.
Timing – A user with the appropriate alarm group can reset alarms for the
area.
Reset – Depending on the application, a user with the appropriate alarm
group can disarm the area for the user category time (in which case
disarming must be permitted), or automatically arm another area via vault
programming (in which case arming must be permitted).
Area permissions for arming, disarming, timing, and for alarm reset can be
modified in two ways:
On a per-area basis from the Areas list. Tick the check box that you want
to toggle.
In bulk, by selecting multiple areas, and then clicking the Edit button.
The Area flags dialog displays. Set the permissions for arming, disarming,
alarm reset, and for timing that you want to apply to all selected areas,
and then click the OK button.
Click the Remove button to remove the selected area from the Areas list.
To Next Page
Loading...
