TECOM TS1066 - Programming User Information; Programming Door Groups; Programming Users

Programming user information
Programming door groups
Note: Typically, door groups will be configured using TecomC4. The following
information is for using CTPlus to program door groups if required.
A NAC in Classic mode inherits the door groups of the ChallengerPlus it is
connected to, so is limited to 255 door groups. You can add NAC doors to
existing door groups or create new ChallengerPlus door groups for the NAC
doors.
A NAC in IP Direct or IP Extended mode uses NAC door groups, of which there
can be up to 10,000.
To add a door group to a NAC or ChallengerPlus panel, follow these steps:
1. Click the Door groups button on the User access ribbon tab to open
the Door groups form.
2. On the Door groups form, click the New button in the toolbar to add a
new door group record.
3. Enter a description for the door group in the Record description field.
4. Ensure the Panel field is set to the correct NAC or ChallengerPlus panel.
If necessary, click the Browse button next to the Panel field to select
the NAC or ChallengerPlus panel.
5. On the Door group tab, click the Assign button to open a dialog to
assign doors to a door group. In the dialog, select the Time zone for the
door group. Move the required doors from the Available doors list to the
Assigned doors list using the button. Areas can be removed from
the Assigned doors list using the button. Click the OK button when
finished.
6. Click the Save button in the toolbar to save the door group record.
Refer to the ChallengerPlus Programming Manual for more information on door
groups. Refer to the CTPlus Operators Manual or CTPlus online help for more
information on the Door groups form.
Programming users
Note: Typically, users will be configured using TecomC4. The following
information is for using CTPlus to program users if required.
A NAC in Classic mode inherits the users of the ChallengerPlus panel it is
connected to, so is limited to 2,000 users (or 65,535 users if the ChallengerPlus
panel has a TS1084 Memory Expansion Module).
A NAC in IP Direct or IP Extended mode has its own user database of up to
250,000 users. You can add new users for the NAC, or configure NAC access
and credentials for existing users in the CTPlus database.