Active on days
Tick the days of the week (and/or holidays) that the door schedule will be active
on during the active period.
Start time
Enter the start time for the start action.
Every hour
Tick the Every hour check box if the Start action is to repeat every hour.
Action duration
The action duration is the period of time that the Start action should remain in
effect. When the action duration expires, the End action will be triggered.
Enter a number and specify Sec for seconds, Min for minutes, Hour for hours, or
Day for days.
Start action
Select the start action from the following options:
No action – take no action
Unlock – unlock the door
Lock – lock the door
Disable – disable the door
Enable – enable the door
End action
If Action duration is defined, select the end action from the options. The options
are the same as for the Start action field. See the “Start action” section above.
Configuring door overrides
For more information on door overrides, see the “Overriding door state” section
on page 24. Programming of a door override is similar to programming a “hard”
panel time zone for a NAC or ChallengerPlus panel.
To Next Page
Loading...
