Need help?Do you have a question about the Tecsis F5301 and is the answer not in the manual?
General| Accuracy class | 0.5 |
|---|---|
| Ingress protection | IP65 |
| Accuracy | ±0.5% FS |
| Output Signal | 4...20 mA |
| Protection Class | III |
| Material | Stainless Steel |
| Housing material | Aluminium, seawater-resistant |
Defines the intended use of load pins for measuring force.
Details the strain gauge technology and construction of the measuring element.
Describes how force is measured and the types of output signals.
Covers the operational temperature range and its impact on accuracy.
Discusses the load pins' resistance to moisture and corrosion.
Warns against deposits affecting the measuring spring.
Lists crucial precautions for safe and accurate load pin assembly.
Provides detailed instructions and precautions for the mechanical installation of load pins.
Explains pin assignments for analog signal outputs like 4-20mA and 0-10V.
Details the pin assignments for ATEX/IECEx certified versions of the load pins.
Explains pin assignments for SIL-3 certified versions based on EN 62061 standard.
Describes pin assignments for redundant analog signal outputs, often used with ELMS1.
Details the pin assignments for load pins using MIL connectors.
Explains the pin assignments for the CANopen® communication interface.
States that standard dimensions are not available, referring to customer-specific drawings.
Provides classification and supplementary information for ATEX explosion-proof equipment.
Outlines repair procedures and warnings for devices in potentially explosive areas.
Lists critical electrical parameters and cable characteristics for ATEX versions.
To Next Page