Teeter FreeStep LT7 - Assembly Step 9: Pedals; Attach Pedals to Linkage Arms

11
Assemble Pedals
Figure 18: Locate the Pedals, noting Right and
Left assembly stickers. Insert the Pedals into their
respective Linkage Arms.
STEP 9
Figure 19a: Hand tighten 4 × Bolts and 4 × Washers
from the Step 9a Hardware Kit.
Figure 19b: Hand tighten 8 × Screws and 8 ×
Washers from the Step 9b Hardware Kit.
Proceed to fully tighten the Bolts with the 6 mm
Allen Wrench and the Screws with the Phillips
Screwdriver.
Once the Pedals are assembled, return
the FreeStep to the upright position.
Figure 19a
Figure 18
Figure 19b
Step 9a Hardware
Step 9b Hardware