● Screw the cover back on again.
When you do this, the cover must
press the top filter fleece mat
against the support surface of the
activated carbon cassette all the
way round.
● Push the filter pack back into the
filter housing. Make sure that the
filter elements are inserted in the
correct order. Then reconnect the
measuring hose at the
intermediate frame.
The seals of the
particle filter, the activated
carbon cassette and the
intermediate frame must always
be on the top.
● Elevate the lifting device by turning
the clamping screw so that the
entire filter pack is pressed tightly
against the above housing.
● Re-establish the two earth
connections.
There is a risk of
explosion during operation if an
earth connection is not
attached.
● Close the service door.
To Next Page
Loading...
