Teka LFE 101 ST1 - Page 48

21.
External control unit (screw)
0.
22.
Industrial plug connector
0.
23.
Connection point for suction
housing (thread)
0.
Measurement points: pipeline
The suction line must have continuous electrostatic conductivity from the individual extraction points
to the filter device.
This must be documented and confirmed using a measurement protocol. The following table can be
used for this purpose. We recommend noting the measured measuring points (and if necessary also
the reference points) in a drawing/photos.
measuring
point
Measuring area /
measurement points
Reference
point
Measurement
voltage [V]
Resistance
[Ohm]
OK
NOK
BA_LFE-101-201-301_ST1_20230808_EN
48
08.08.2023