Tekmar 521 - Mounting the Thermostat

© 2020 521_D - 12/20
5 of 28
A Watts Water Technologies Company
Mounting The Thermostat
If mounting directly to the wall:
• Drill holes and install the wall anchors.
• Feed the wiring through the large hole in the thermostat base.
• Fasten the thermostat base to the wall using the wood screws to the wall
anchors.
• Terminate wiring to the wiring strip.
• Push the thermostat front onto the thermostat base.
If a single gang box is used:
• Adapter Plate 012 is required (sold separately).
• Feed the wiring through the hole in the adaptor plate and the thermostat base.
• Fasten the adaptor plate to the gang box.
• Fasten the base of the thermostat to the adaptor plate.
• Terminate wiring to the wiring strip.
• Push the thermostat front onto the thermostat base.
Wall
Thermostat
Front
Thermostat
Base
3
1
/4"
(83 mm)
Stud
Gang
Box
Thermostat
Front
Thermostat
Base
Adapter Plate 012