Tektronix 5 Series MSO Printable Help

Field or control Description
Trigger When Sets the trigger when condition.
When set to Inside Range or Outside Range, fields are displayed to set a high and low
boundary pattern for the specified trigger type.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = Frame ID, Cycle Count, Data, or Identifier & Data.
Frame Type Sets the end of frame type on which to trigger (Static, Dynamic (DTS), ALL).
Available when Trigger On = End of Frame.
A, B knob controls Use the A knob to select (highlight) the digit(s) to change.
Use the B knob to change the value of the digit(s).
Menus and dialog boxes
354 MSO54, MSO56, MSO58, MSO58LP, MSO64 Help

Tektronix 5 Series MSO Specifications

General

Brand	Tektronix
Model	5 Series MSO
Category	Test Equipment
Language	English