Tektronix AA 501 - CALIBRATION; Table 4-1 Updates; Performance Check Step Modifications

CALIBRATION
Section 4
Add to Table 4-1, page 4-1:
Under PERFORMANCE CHECK STEP column,
first equipment
1 isted (Low distortion.. . ) add:
... 12,13,14,16
After second equipment 1 isted (Sinewave oscillator.. . ) add:
Add to Table 4-1, page 4-2:
Under PERFORMANCE CHECK STEP column, first equipment
1 isted (50 n coaxial.. . ) add:
. . .12,13,14,16
Under PERFORMANCE CHECK STEP column, second equipment 1 isted (Bnc female. . . ) add :
... 13,14,16
\
Function geflehdtoh
Page 4-3, change the following steps
under Performance Check Steps to read:
3.
..,Function Accuracy and Input Ranga
6.
... Distortion Accuracy, Uinimum lnp& Lev& and Fundamental Faequency Range
8. .. .SMPTE/DIN Mode (Option 01 oh 02 only)
9. ... Tone Test Mode (Option 01 oh 02 only)
10.
. . .SMPTE Test (Option 01 oh 02 only)
11. ... Tone Test (Option 01 oh 02 only)
11A.
... step 11 is performed, Option 01 oh 02 only)
ThggmbLe, 2 V mcs
200 Hz
csinwve 0LLtpU;t
I
Add r
16. Chech 2-Ph Raponbe Dynamic ChaAucteYdficis (Opfion 02 ody)
16
Pane 4 of 11
Scans by MIEK MEDIA ==-