Tektronix AA 501 User Manual

Add the following step to page 4-16:
16.
Check Q-pk Raponse Dynamic ChahademhXic (OpXion 02 only)
NOTE
The 60UoULing phoceduhe A. 0pXiona-l.
It chechn
the peak-hold dljnamic chatrac/t&Xic 06 the Q-PK
de/tedoa CihcLLi;t)ty.
It A genWy su66icien.t
to v&6y phopm upmation and A phovided in lieu
06 the complex phocedwla dedined in CCIR Recom-
mendatLo~l 468-2 oh DIN 45405.
a. Select the 2 V INPUT RANGE, LEVEL FUNCTION, VOLTS, and Q-PK RESPONSE.
Make
cWn all FILTERS puhbUM:om ahe out.
b. Connect the output 06 the FG 501A wgmable unction genmatoh to
the
INPUT 06 the AA 501.
Conned the output 06 the SG 505 osuXlatofi
to the x%i.ggm inpult 06 the FG 501A.
c.
SeZ the dinemwe oultpult 6heque.ncy 06 the FG 501A to 200 Hz in the
6hee hun mode.
d. Adjwt the FG 501A oatput ampWde untie the AA 501 dinplays apphoxi-
matdy 1.6 V.
e.
Pwh the
dB RATIO puhbuon and pwh and h&me the PUSH TO SET 0 dB REF
puhbuon.
Note that the AA 501 dinplays a heading 06 0.0 dB.
6.
Set the oultpult &~eque.ncy 06 the SG 505 to 10 Hz w-Lth maximum oultpult ampa-
Xude [appoximat&y 6 V ms 1 .
g.
Change the FG 5019 to the .thiggmed mode.
Make
can the phae conMol
setting .i~ nm 0 .
(The FG jO1A ouXput signal should be a single cyde
bmt 06
200 Hz b&vu%Ig at 0 phae at a 10 Hz hepWon me. I
h. CHECK - that the AA 501 dinplay heah
6hom -2.7 dB to - 1.9 dB.
Change step 2 on page 4-19 to read:
2. Adjust Rms,
Avg Zero, and [OpXion 021 Q-Pk Zmo
Add the following to step 29 on page 4-19:
g.
. . .Avg Zero, (OptLon 02, R1334, Q-Pk Zmo), for a display.. .
Change step 39 on page 4-19 to read:
g.
(s&ndand and OptLon 01 ivlnhumentnl ADJUST - R1301, ...
Page 9 of 11
Scans by ARTEK MEDL4 =>

Tektronix AA 501 Specifications

General

Brand	Tektronix
Model	AA 501
Category	Measuring Instruments
Language	English