Trigger Setup
6. Push Trigger On and turn multipurpose knob
a to scroll through the side-bezel menu until
you select the desired trigger on feature.
If you a re using the parallel bus trigger, you
can trigger on a binary or hex data v alue.
Push the lower-bezel Data button and enter
the parameters of interest with multipurpose
knobs a and b.
IfyouareusingtheI
2
C bus trigger, you
can trigger on Start, Repeated Start,
Stop, Missing Ack, Address, Data,or
Address/Data.
If you are using t he SPI bus trigge r, you can
trigger on SS Active, MOSI, MISO,orMOSI
&MISO.
If you are using the CAN bus trigger, yo u can
trigger on Start of Frame, Type of Frame,
Identifier, Data, Id & Data, End of Frame,
Missing Ack,orBit Stuffing Error.
If you are using the RS-232 bus trigger, you
can trigger on Tx Start Bit, Rx Start Bit, Tx
End of Packet, Rx End of Packet,Tx Dat a,
Rx Data, Tx Parity Error,orRx Parity Erro r.
DPO2000 and MSO2000 Series Oscilloscopes User Man ual 137
To Next Page
Loading...
Need help?
General
