Commands Listed in Alphabetical Order
MEASUrement:
MEAS<x>:REFLevel<x>:RELative:HIGH
This command sets or queries the percent of the High/Low range that the
instrument uses to calculate the high reference level for the specified measurement,
where 100% is
equal to the High/Low range. The measurement slot is specified
by x, which can be 1 through 8. The reference level source is specified x, which
can only be 1 for this mea surement (or defaults to 1 if not specified).
This percentage is used to calculate the high reference level when
MEASUrement:MEAS<x>:REFLevel<x>:METHod is set to RELative. Sending
this command is equivalent to selecting Relative in the Refere nce Level Calc
Method section of the RefLevel dialog and then entering a percentage f or Hi in
the Reference section of the Measurement Setup dialog box.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:REFLe vel<x>:RELative:HIGH <NR2 >
MEASUrement:MEAS<x>:REFLe vel<x>:RELative:HIGH?
Related Commands
MEASUrement:MEAS<x>:REFLevel<x>:METHod
Arguments
NR2 can be from 0 to 100 (percent) and is the high reference level. The default is
90 (percent).
Examples
MEASUREMENT:MEAS3:REFLEVE L1:RELATIVE:HIGH 95 sets the high
reference level for Measurement 3 to 95% of the High/Low range.
MEASUREMENT:MEAS2:REFLEVE L1:RELATIVE:HIGH? might return
MEASUREMENT:MEAS2:REFLEVE L1:PERCENT:HIGH 9.00000000000E+ 001,
indicating that the high reference level for Measurement 2 to is set to 90% (the
default value) of the High/Low range.
MEASUrement:MEAS<x>:REFLevel<x>:RELative:LOW
This command sets or queries the percent of the High/Low range that the
instrument uses to calculate the low reference level for the specified measurement,
where 100% is equal to the High/Low range. The measurement slot is specified
by x, which can be 1 through 8. The reference level source is specified x, which
can only be 1 for this mea surement (or defaults to 1 if not specified).
This percentage is used to calculate the low reference level when
MEASUrement:MEAS<x>:REFLevel<x>:METHod is set to RELative. Sendin
g
this command is equivalent to selecting Relative in the Refere nce Level Calc
2-234 DSA/CSA/TDS8X00/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
