Command Groups
Table 2-18: Acquisition Commands (cont.)
Command Description
ACQuire:SAVEFile:SAVEWfm Sets or returns the file to save waveform
data to on acquisition stopped
ACQuire:STATE Starts, stops, or returns acquisition state
ACQuire:STOPAfter? Returns all stopafter parameters
ACQuire:STOPAfter:ACTion Sets or returns the stopafter action
ACQuire:STOPAfter:BELL Sets or returns whether to sound bell on
acquisition stopped
ACQuire:STOPAfter:CONDition Sets or returns the acquisition stopafter
condition
ACQuire:STOPAfter:COUNt Sets or returns the stopafter count value
The stopafter count value is
dependent on the condition set by the
ACQuire:STOPAfter:CONDiton command
ACQuire:STOPAfter:MODe Sets or returns the stopafter mode
Calibration Command Group
The calibration commands provide information about the current state of the
calibration for the mainframe and all resident sampling-module channels.
Additional commands allow you to update portions of the “electronic calibration
sticker” information, to check the protection s tatus of the calibration information,
and to set or query the front-panel DC calibration output.
Command
Description
CALibrate:DATE:CH<x>? Returns date and time of the last sampling
module channel<x> calibration
CALibrate:DATE:MAInframe? Returns the date and time of the last
mainframe calibration
CALibrate:DCCALibrator Sets or returns the value of the D C Calibrator
voltage
CALibrate:HOSTinfo:CH<x>? Returns the mainframe model number, serial
number, and mainframe channel<x> in which
the sampling module channel was located
during the last calibration information update.
CALibrate:LOCK:STATus? Returns the status of the calibration
protection mode.
CALibrate:STATus:CH<x>? Returns calibration status for specified
sampling module channel<x>
CALibrate:STATus:MAInframe? Returns calibration status for mainframe
2-14 DSA/CSA/TDS8X00/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
