Tektronix DSA8200 Series User Manual

Command Groups
Command
Description
HIStogram:BOXPcnt Sets or returns same as HIStogram:BOX, but
in percentage coordinates, with 0,0 upper left
and 100,100 lo
wer right
HIStogram:C
OLOr
Sets or retur
ns the histogram color
HIStogram:
COUNt
Clears hist
ogram count source data and
restarts counting
HIStogram:DISplay Sets or returns whether histogram data is
displayed on screen
HIStogram:ENABle
Enables or disables histogram calculations
Returns whether histogram calculations are
enabled
HIStogra
m:MODe
Sets type
of histogram to be done, either
vertical or horizontal
Returns the type of histogram
HIStogram:SIZe Sets or returns the width (or height) of the
histog
ram on the screen in divisions
HIStog
ram:SOUrce
Sets or
returns the source waveform
and timebase (Main, Mag1, or Mag2) for
histogram
HIStogram:STATistics?
Returns all histogram statistics
HIStogram:STATistics:HITS?
Returns the histogram total hits value
HIStogram:STATistics:MEAN?
Returns the histogram mean value
HIStogram:STATistics:MEDIAN?
Returns the histogram median value
HIStogram:STATistics:PEAKHits?
Returns the histogram peak hits value
HIStogram:STATistics:PKTOPK?
Returns the histogram peak to peak value
HIStogram:STATistics:SIGMA<x>? Returns population density for ±<x> sigma
v
alue
H
IStogram:STATistics:STDdev?
Returns the histogram standard deviation
v
alue
HIStogram:STATistics:WAVeforms? Returns the number of waveforms used in
histogram
HIStogram:TYPE Sets or returns whether the histogram is
displayed linearly or logarithmically
HIStogram:WFMDB:STATE Sets or returns whether the histogram
counting is on a waveform database
Horizontal Command Group
You use the commands from the Horizontal Command Group to control the
timebases of the instrument. You can use these commands to do the following:
DSA/CSA/TDS8X00/B Series Programmer Manual 2-21

Tektronix DSA8200 Series Specifications

General

Brand	Tektronix
Model	DSA8200 Series
Category	Test Equipment
Language	English