Operation
Creating a Frequency Mask
Use the Mask Editor to create a Frequency Mask. The mask is a set of points defined by frequency and amplitude. Access
the Mask Editor from the Trigger control panel. (This procedure uses the Spectrum display.)
You can create a Frequency Mask by using either the manual or Auto Draw method. The following procedure explains the
manual method. For a procedure on how to use the Auto Draw method, see the topic Mask Editor (Frequency Mask
Trigger) in the online help.
1. Click Trig to open the Trigger control
panel.
2. Select the
Event tab in the control panel.
3. Set the Sou
rce to RF Input.
4. Set the Typ
etoFrequency Mask.
5. Click Mas
kEditorto open the Mask
Editor.
The Mask Editor opens with the traces of
the Spect
rum display in the graph.
6. Click Ne
w in the tool bar. This removes
the existing mask and then creates a
default 6-point mask.
RSA6100A Series & RSA5100A Series Q uick Start User Manual 51
To Next Page
Loading...
