20
Manual Measurements
The following exercise will explore making manual waveform measurements.
Reset the oscilloscope back to a known starting point and use the front-panel controls to create the
display shown below.
Normally, for greatest accuracy, the waveform is adjusted vertically to fill as much of the display as
possible. For this exercise, leave the waveform as shown above.
1 Push the Default Setup front-panel button
2 Push the AutoSet front-panel button
3 Adjust the vertical scale factor to 1 V/div using the front-panel vertical scale knob
4 Position the waveform at the bottom of the display using the front-panel vertical position
knob
5 Set the horizontal scale factor to 250 µsec/div using the front-panel horizontal scale knob
To Next Page
Loading...
Need help?
General
