Tektronix TDS 200-Series Service Manual

Service Manual
TDS 200-Series
Digital Real-Time Oscilloscope
071-0492-02
This document supports firmware version 1.00
and above.
Warning
The servicing instructions are for use by
qualified personnel only. To avoid personal
injury, do not perform any servicing unless you
are qualified to do so. Refer to all safety
summaries prior to performing service.
www.tektronix.com

Tektronix TDS 200-Series Specifications

General

Channels	2 or 4
Record Length	2.5k points
Input Coupling	AC, DC, GND
Sample Rate	1 GS/s
Display	5.7-inch monochrome LCD
Vertical Resolution	8-bit
Trigger Modes	Edge, Video, Pulse
Connectivity	USB, RS-232
Power Supply	100 to 240 VAC, 45 to 440 Hz