Tektronix TDS 200-Series Instructions

TDS 200-Series Extension Module Instructions
1
Getting Started
This chapter describes important module and oscilloscope dependen-
cies, and how to install and check the TDS 200-Series extension
modules.
Read Me First
NOTE. Read the following text before installing your module. To
display oscilloscope and module firmware version numbers, press
UTILITY
 System Status  Misc.
TDS2MM and TDS 200-Series
The TDS2MM Module only operates on TDS 200-Series oscillo-
scopes with firmware version v1.06 and greater. Contact Tektronix
for information on how to upgrade your TDS 200-Series oscilloscope
firmware.
Seiko Printer Support
Seiko printer support (DPU411, DPU412) is only available with the
following firmware configurations:
Module and firmware TDS 200 firmware
TDS2HM v1.00 and greater v1.09 and greater
TDS2CM v1.04 and greater
1
v1.09 and greater
TDS2MM v1.00 and greater v1.06 and greater
1
You cannot select the DPU411 or DPU412 over a
remote interface with TDS2CM v1.03 and earlier.

Tektronix TDS 200-Series Specifications

General

Brand	Tektronix
Model	TDS 200-Series
Category	Test Equipment
Language	English