Tektronix TDS 200-Series - TDS2 MM Measurement Module

TDS 200-Series Extension Module Instructions
27
TDS2MM Measurement Module
This section describes the operation of the TDS2MM Measurement
Extension Module. The TDS2MM Module includes all communica-
tions capabilities of the TDS2CM Module, and adds these new
measurement capabilities to the TDS 200-Series oscilloscopes:
 Rise time, fall time, positive pulse width, and negative pulse
width (discussed in Signal Measurements, on page 29)
 Fast Fourier Transform (FFT) (discussed in Using the FFT,
starting on page 30)