Preface
TDS 200-Series Extension Module Instructions
v
Command Entry
Follow these general rules when entering oscilloscope commands
over the RS-232 or GPIB bus:
You can enter commands in upper or lower case.
You can abbreviate many oscilloscope commands. These
abbreviations are shown in uppercase letters. For example, the
command ACQuire:NUMAVg can be entered simply as
ACQ:NUMAV or acq:numav.
You can precede any command with white space characters.
White space characters include any combination of the ASCII
control characters 00 through 09 and 0B through 20 hexadecimal
(0 through 9 and 11 through 32 decimal).
The oscilloscope ignores commands that consist of just a
combination of white space characters and line feeds.
To Next Page
Loading...
