Tektronix TDS 200-Series Instructions

TDS2HM Hard Copy Module
TDS 200-Series Extension Module Instructions
9
Testing the Hard Copy Port
1. If you have already connected the oscilloscope to a printer, go to
step 4.
2. Turn off the oscilloscope and the printer.
3. Connect the oscilloscope to the printer using the appropriate
cable.
4. Turn on the oscilloscope and the printer.
5. If you have not done so already, do the hard copy setup
appropriate for your extension module. Refer to page 8.
6. On the oscilloscope, push the HARDCOPY button. The printer
should begin printing a copy of the oscilloscope screen after a
few seconds.
Printing an Oscilloscope Screen
To print the screen data, push the HARDCOPY button. The
oscilloscope takes a few seconds to capture the screen data and send
it to the printer. The printer then begins printing a copy of the
oscilloscope screen. Your printer settings determine how long it
takes to print the screen data.

Tektronix TDS 200-Series Specifications

General

Brand	Tektronix
Model	TDS 200-Series
Category	Test Equipment
Language	English