TDS 420A, TDS 430A, TDS 460A & TDS 510A User Manual
B–1
Appendix B: Packaging for Shipment
If you ship the digitizing oscilloscope, pack it in the original shipping carton and
packing material. If the original packing material is not available, package the
oscilloscope as follows:
1. Obtain a corrugated cardboard shipping carton with inside dimensions at
least 15 cm (6 in) taller, wider, and deeper than the digitizing oscilloscope.
The shipping carton must be constructed of cardboard with 170 kg
(375 pound) test strength.
2. If you are shipping the digitizing oscilloscope to a Tektronix field office for
repair, attach a tag to the digitizing oscilloscope showing the oscilloscope
owner and address, the name of the person to contact about the oscilloscope,
the oscilloscope type, and the serial number.
3. Wrap the digitizing oscilloscope with polyethylene sheeting or equivalent
material to protect the finish.
4. Cushion the digitizing oscilloscope in the shipping carton by tightly packing
dunnage or urethane foam on all sides between the carton and the digitizing
oscilloscope. Allow 7.5 cm (3 in) on all sides, top, and bottom.
5. Seal the shipping carton with shipping tape or an industrial stapler.
CAUTION. Do not ship the digitizing oscilloscope with a disk inside the disk
drive. When the disk is inside the drive, the disk release button sticks out. This
makes the button more prone to damage than otherwise.
To Next Page
Loading...
Need help?
General
