Tektronix TDS 420A - Primary Troubleshooting Procedure

Command Descriptions
2–218
TDS Family Oscilloscope Programmer Manual
MEASUrement:IMMed:UNITS? (Query Only)
Returns the units for the immediate measurement.
Measurement
MEASUrement:IMMed:TYPe
 





  returns  for volts,  for seconds, " for hertz,  for
volts
2
,or  for percent.
On the TDS 400A,   also returns  for clocks,  for volt-clocks,
or  for 1/clks.

might return , indicating that the units for the immediate measurement are
seconds.
MEASUrement:IMMed:VALue? (Query Only)
Immediately executes the immediate measurement specified by the MEASUre-
ment:IMMed:TYPe command. The measurement is taken on the source(s)
specified by a MEASUrement:IMMed:SOURCE command.
Measurement
 !



!


Group
Related Commands
Syntax
Returns
Examples
Group
Syntax
Returns