Command Groups
TDS Family Oscilloscope Programmer Manual
2–19
Table 2–10: File System Commands (Cont.)
Header Description
FILESystem:RMDir Delete named directory
FILESystem:WRITEFile
(TDS 500C & 700C)
Copy from GPIB port to file
Hardcopy Commands
Hardcopy commands let you control the format of hardcopy output and the
initiation and termination of hardcopies. Table 2–11 lists these commands.
Table 2–11: Hardcopy Commands
Header Description
HARDCopy Start or terminate hardcopy
HARDCopy:FILEName
(File System only)
Select file to send hardcopy data to
HARDCopy:FORMat Hardcopy output format
HARDCopy:LAYout Hardcopy orientation
HARDCopy:PALEtte
(TDS 6X4B & 700C)
Select palette to use when making hardcopy
HARDCopy:PORT Hardcopy port for output
Histogram Commands
Histogram commands let you select the type of histogram, what part of the
waveform should go into the histogram, and histogram statistics. Table 2–12 lists
these commands.
Table 2–12: Histogram Commands
Header Description
HIStogram?
(TDS 500C & 700C)
Queries the state of all settable parameters
related to histograms
HIStogram:BOX
(TDS 500C & 700C)
Defines the left, top, right, and bottom
positions of the histogram box, in source
waveform coordinates
To Next Page
Loading...
Need help?
General
