EasyManuals Logo

Tektronix TDS 420A Programmer's Manual

Tektronix TDS 420A
433 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #399 background imageLoading...
Page #399 background image
Status and Events
TDS Family Oscilloscope Programmer Manual
3–19
Table 3–8: Execution Warning Messages – EXE Bit 4 (Cont.)
Code Message
544 Measurement warning, Uncertain edge
545 Measurement warning, Invalid in minmax
546 Measurement warning, Need 3 edges
547 Measurement warning, Clipping positive/negative
548 Measurement warning, Clipping positive
549 Measurement warning, Clipping negative
550 InstaVu active – deactivate to see change
551 InstaVu active – deactivate to use math
552 EAL on – turn off to see change
(EAL = extended-acquisition-length mode)
553 EAL on – turn off to use math
(EAL = extended-acquisition-length mode)
570 Saveref warning, decimated 500K waveform to 250K Ref (TDS 700A)
571 Option 05 not present
572 Option 2F not present
Table 3–9 shows internal errors that indicate an internal fault in the digitizing
oscilloscope.
Table 3–9: Internal Warning Messages
Code Message
600 Internal warning
620 Internal warning, Bad thermistor
630 Internal warning, 50 overload

Table of Contents

Other manuals for Tektronix TDS 420A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix TDS 420A and is the answer not in the manual?

Tektronix TDS 420A Specifications

General IconGeneral
BrandTektronix
ModelTDS 420A
CategoryTest Equipment
LanguageEnglish

Related product manuals