Tektronix TDS 420A - Table 3-8: Execution Warning Messages - EXE Bit 4

Status and Events
3–18
TDS Family Oscilloscope Programmer Manual
Table 3–7: System Event Messages (Cont.)
Code Message
440 Query UNTERMINATED after indefinite response (QYE bit 2 set)
450 Right menu button #1 pushed (URQ bit 6 set)
451 Right menu button #2 pushed (URQ bit 6 set)
452 Right menu button #3 pushed (URQ bit 6 set)
453 Right menu button #4 pushed (URQ bit 6 set)
454 Right menu button #5 pushed (URQ bit 6 set)
460 Bottom menu button #1 pushed (URQ bit 6 set)
461 Bottom menu button #2 pushed (URQ bit 6 set)
462 Bottom menu button #3 pushed (URQ bit 6 set)
463 Bottom menu button #4 pushed (URQ bit 6 set)
464 Bottom menu button #5 pushed (URQ bit 6 set)
465 Bottom menu button #6 pushed (URQ bit 6 set)
466 Bottom menu button #7 pushed (URQ bit 6 set)
Table 3–8 lists warning messages that do not interrupt the flow of command
execution. These notify you that you may get unexpected results.
Table 3–8: Execution Warning Messages – EXE Bit 4
Code Message
500 Execution warning
510 String data too long, truncated
525 Parameter underrange
526 Parameter overrange
527 Parameter rounded
528 Parameter out of range
530 Data stop > stop, Values swapped internally
531 Data stop > record length, Curve truncated
532 Curve data too long, Curve truncated
540 Measurement warning
541 Measurement warning, Low signal amplitude
542 Measurement warning, Unstable histogram
543 Measurement warning, Low resolution