Command Descriptions
2–220
TDS Family Oscilloscope Programmer Manual
Measurement
& " #()*
& " #(
)
*
might return
.
MEASUrement:MEAS<x>:DELay:DIREction
Sets or queries the starting point and direction that determines the delay “to”
edge when taking a delay measurement. The waveform is specified by
MEASUrement:MEAS<X>:SOURCE2. This command is equivalent to setting
the direction in the Delay Edges & Direction side menu.
Measurement
& " #()*(!$# + &' , &' -
& " #()*(!$#
& " #(
)
*
(!$#
%
&'
&'
&' means that the search starts at the end of the waveform and looks for
the last rising or falling edge in the waveform. The slope of the edge is specified
by MEASUrement:MEAS<x>:DELay:EDGE2.
&' means that the search starts at the beginning of the waveform and
looks for the first rising or falling edge in the waveform. The slope of the edge is
specified by MEASUrement:MEAS<x>:DELay:EDGE2.
starts searching from the end of the waveform record.
Group
Syntax
Examples
Group
Syntax
Arguments
Examples
To Next Page
Loading...
Need help?
General
