Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–251
Status and Error
FACtory, *PSC, *RCL, RECAll:SETUp, *SAV, SAVe:SETUp
*RST returns the instrument settings to the factory defaults (see Appendix D:
Factory Initialization Settings).
The *RST command does not alter the following:
H The state of the IEEE Std 488.1–1987 interface.
H The selected IEEE Std 488.1–1987 address of the digitizing oscilloscope.
H Calibration data that affect device specifications.
H The Output Queue.
H The Service Request Enable Register setting.
H The Standard Event Status Enable Register setting.
H The Power-on status clear flag setting.
H Alias definitions.
H Stored settings.
H The *PUD? response.
RS232:BAUd
RS-232/Centronics Hardcopy Interface Only
Sets or queries RS-232-C interface transmission speed.
RS232
Group
Related Commands
Syntax
Group
Syntax
To Next Page
Loading...
