Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–255
RS232? (Query Only)
RS-232/Centronics Hardcopy Interface Only
Queries the RS232 settings.
RS232
RS232?
RS232 ?
None
RS232? queries for RS232 settings.
It might return:
RS232 BAUD: 9600, SOFTFLAGGING: OFF, HARDFLAGGING: ON, PARITY:
NONE, STOPBITS: 1
*SAV (No Query Form)
(Save) stores the state of the digitizing oscilloscope into a specified memory
location. You can later use the *RCL command to restore the digitizing
oscilloscope to this saved state. This is equivalent to selecting the Save Current
Setup in the Save/Recall Setup menu.
Save and Recall
DELEte:SETUp, FACtory, *RCL, RECAll:SETUp, SAVe:SETUp
*SAV <NR1>
<NR1>
*SAV
<Space>
<NR1> is a value in the range from 1 to 10 and specifies a location. Using an
out-of-range value causes an execution error. Any settings that have been stored
previously at this location will be overwritten.
Group
Syntax
Arguments
Examples
Group
Related Commands
Syntax
Arguments
To Next Page
Loading...
