Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–261
turns the channel 2 display on and selects channel 2.
returns either or , indicating whether the REF1 waveform is selected.
SELect:CONTROl
Sets or queries the waveform that is currently affected by the cursor and vertical
commands.
<wfm> can be CH<x>, MATH<x>, or REF<x> except in extended-acquisition-
length and InstaVu modes where MATH<x> is not used.
Vertical
is CH<x>, MATH<x>, or REF<x>, and is the selected waveform.
might return as the selected waveform.
SET? (Query Only)
Returns a string listing the digitizing oscilloscope settings, except for configura-
tion information for the calibration values. You can use this string to return the
digitizing oscilloscope to the state it was in when you made the SET? query.
This command is identical to the *LRN? command.
Miscellaneous
HEADer, *LRN?, VERBose
Examples
Group
Syntax
Arguments
Examples
Group
Related Commands
Syntax
To Next Page
Loading...
