Tektronix TDS 420A - Page 283

Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–269
  !  "  #
 








 

 specifies to trigger on the falling or negative edge of a signal.
 specifies to trigger on the rising or positive edge of a signal.

might return , indicating that the delayed trigger occurs on the rising edge.
TRIGger:DELay:EDGE:SOUrce
Selects the source for the delayed trigger. This command is equivalent to
selecting Source in the Delayed Trig menu.
Trigger
  !  (not available on TDS 520C &
724C) "  #
 






 




 specifies an external trigger using the Auxiliary Trigger Input
connector that is located on the rear panel of the instrument. The TDS 520C &
724C do not have an Auxiliary Trigger input and so do not support this
argument.
Syntax
Arguments
Examples
Group
Syntax
Arguments