Command Descriptions
2–54
TDS Family Oscilloscope Programmer Manual
might return , indicating that repetitive signal acquisition mode is on.
ACQuire:STATE
Starts or stops acquisitions. This is the equivalent of pressing the front-panel
RUN/STOP button. If ACQuire:STOPAfter is set to SEQuence, other signal
events may also stop acquisition.
Acquisition
ACQuire:NUMACq?, ACQuire:REPEt, ACQuire:STOPAfter
or or = 0 stops acquisitions.
or or 0 starts acquisition and display of waveforms. If the
command was issued in the middle of an acquisition sequence (for instance
averaging or enveloping), restarts the sequence, discarding any data
accumulated prior to the . It also resets the number of acquisitions.
starts acquisition of waveform data and resets the number of acquisitions count
(NUMACQ) to zero.
returns either or , depending on whether the acquisition system is running.
Group
Related Commands
Syntax
Arguments
Examples
To Next Page
Loading...
Need help?
General
