Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–71
might return , which indicates that there is no bandwidth limiting on
channel 1.
CH<x>:COUPling
Sets or queries the input attenuator coupling setting of the specified channel.
This is equivalent to setting Coupling in the Vertical menu.
Vertical
CH<x>:IMPedance
! " " #
sets the specified channel to AC coupling.
sets the specified channel to DC coupling.
sets the specified channel to ground. Only a flat ground-level waveform will
be displayed.
establishes AC coupling on channel 1.
might return , indicating that channel 3 is set to DC coupling.
Group
Related Commands
Syntax
Arguments
Examples
To Next Page
Loading...
Need help?
General
