Tektronix TDS2014 User Manual

Application Examples
64
TDS1000/2000-Series Digital Oscilloscope User Manual
Triggering on Video Lines
Automatic. You can also look at the video lines in the field. To trigger
on the video lines, follow these steps:
1. Push the AUTOSET button.
2. Push the top option button to select Line to sync on all lines.
(The AUTOSET Menu incl udes All Lines and Li ne Number
options.)
Manual. An alternative method requires more steps, but may be
necessary depending on t he video signal. To use the method, follow
these steps:
1. Push the TRIG MENU button to see the Trigger Menu.
2. Push the top option button and select Video.
3. Push the Sync option button and select All Lines.orLine
Number andturntheUSER SELECT knob to set a specific line
number.
4. Push the Standard option button and select NTSC.
5. Turn the SEC/DIV knob to see a complete video line across the
screen.
6. Turn the VOLTS/DIV knob to ensure that the entire video signal
is visible on the scre en.

Tektronix TDS2014 Specifications

General

Channels	4
Bandwidth	100 MHz
Sample Rate	1 GS/s
Record Length	2.5k points
Vertical Resolution	8 bits
Vertical Sensitivity	2 mV/div to 5 V/div
Timebase Range	5 ns/div to 50 s/div
Display Resolution	320 x 240 pixels
Display	5.7 inch color LCD
Trigger Types	Edge, Video
Interface	USB
Input Impedance	1 MΩ
Power Requirements	100 to 240 V