EasyManuals Logo
Home>Tektronix>Monitor>WFM7020

Tektronix WFM7020 User Manual

Tektronix WFM7020
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Compliance Info
rmation
Safety Compliance
EC Declaration of Conformity Low Voltage
Compliance was demonstrated to the following specication as listed in the Ofcial Journal of the European Communities:
Low Voltage Directive 2006/96/EC.
EN 61010-1: 2001. Safety requirements for electrical equipment for m easurem ent control and laboratory use.
U.S. Nationally R ecog nized Testing Laboratory Listing
UL 61010B-1:2004, 2
nd
Edition. S tandard for electrical measuring and test equipment.
Canadian Certication
CAN/CSA-C22.2 No. 61010-1:2004. Safety requirements for electrical equipment for measurement, control, and
laboratory use. Part 1.
Additional Compliances
IEC 61010-1: 2001. Safety requirements for electrical equipment for measurement, control, and labo
ratory use.
ISA S82.02.01:1999. Safety standard for electrical and electronic test, measuring, controlling, and related equipment.
Equipment Type
Test and measuring equipment.
Safety Class
Class 1 grounded product.
Pollution Degree D escription
A measure of the contaminants that could occur in the environment around and within a product. Typically the internal
environment inside a product is considered to be the same as the external. Products should be used only in the environment
for which they are rated.
Pollution Degree 1. No pollution or only dry, nonconductive pollution occurs. Products in this category are generally
encapsulated, hermetically sealed, or located in clean rooms.
Pollution Degree 2. Normally only dry, nonconductive pollution occurs. Occasionally a temporary conductivity that is
caused by condensation must be expected. This location is a typical ofce/home e
nvironment. Temporary condensation
occurs only when the product is out of service.
Pollution Degree 3. Conductive pollution, or dry, nonconductive pollution that becomes conductive due to condensation.
These are sheltered l ocations where neither temperature nor humidity is c ontrolled. The area is protected from direct
sunshine, rain, or direct wind.
Pollution Degree 4. Pollution that generates persistent conductivity through conductive dust, rain, or snow. Typical
outdoor locations.
Waveform Monitors Quick Start User Manual vii

Table of Contents

Other manuals for Tektronix WFM7020

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix WFM7020 and is the answer not in the manual?

Tektronix WFM7020 Specifications

General IconGeneral
BrandTektronix
ModelWFM7020
CategoryMonitor
LanguageEnglish

Related product manuals