Telecom Behnke 20-0001BS Series - 4.6. Operation as Analogue (a;b) Intercom Station

73www.behnke-online.de
GB
Instructions SIP intercoms series 20-0001BS, 20-0014BS, 20-0016BS
Commissioning and configuration
4.5. Reset to factory setting
Connect the SIP intercom station to the network
Wait until the SIP intercom station is started
(see point 2 Start of the intercom station).
Press the configuration key once and follow the
prompts (to reset from factory setting, press
and hold the configuration key for at least 5
seconds).
4.6. Operation of the hybrid intercom
station as analogue (a/b) intercom
station
The configuration of the intercom station is
done via:
a. DTMF post-dialling through another
analogue phone
b. the intercom station's own WiFi
(Start network configuration mode
see item 5 on page 70)
c. if the intercom station is integrated in a
network infrastructure via the web interface of
the intercom station through a PC