© Telect, Inc., All Rights Reserved, 123518-9 A0
1.509.926.6000 :: telect.com
4
Dual-Feed 200A 4/5 TPA/GMT Fuse Alarm Panel
Power :: 009-8005-0404 :: 009-8005-0404G :: 009-8005-0404L
ALERT! Only qualied personnel may install and maintain this product. Verify that all connections
meet requirements specied in local electric codes or operating company guidelines before supplying
power. Protect this equipment with a fuse or breaker sufficient to interrupt power levels specied on
preceding page.
This product must be installed within a restricted access location where access is through the use of
a tool, lock and key, or other means of security, and is controlled by the authority responsible for the
location.
Inspection
Please read and understand all instructions before starting installation. If you have questions, contact Telect
Technical Support at support@telect.com or call 1.509.926.6000.
When you receive the equipment, carefully unpack it and compare it to the packaging list. Please report any
defective or missing parts to Telect Quality at quality@telect.com or call 1.509.926.6000.
Telect is not liable for transit damaged. If the product is damaged, please report it to the carrier and contact
Telect Quality.
ALERT
!
• Elevated Operating Ambient Temperature :: If you install the rack in a closed or multi-unit rack assembly, the
operating ambient temperature of the rack environment may be greater than room ambient. Therefore, take care
to install the equipment in an environment compatible with the maximum operating temperature.
• Reduced Air Flow :: Installation of the equipment in a rack should be such that the amount of air ow required
for safe operation of the equipment is not compromised.
• Mechanical Loading :: Mounting of the equipment in the rack should be such that a hazardous condition is not
achieved due to uneven mechanical loading.
• Circuit Overloading - Give consideration to the connection of the equipment to the supply circuit and the effect
that overloading of the circuits might have on overcurrent protection and supply wiring. Use appropriate consid-
eration for equipment nameplate ratings when addressing this concern.
• Reliable Earthing :: Maintain reliable earthing of rack-mounted equipment. Pay particular attention to supply
connections other than direct connections to the branch circuit (e.g., use of power strips).
• Disconnect Device :: Incorporate a readily accessible disconnect device in the building installation wiring.
1.2 Important Installation Guildelines
To Next Page
Loading...