Linea 2K and 4K Monochrome Line Scan Camera User's Manual 63
Teledyne DALSA 03-032-20206-00
File Access Control Feature Descriptions
Selects the file to access. The file types which
are accessible are device-dependent.
Upload new FPGA to the camera which will
execute on the next camera reboot cycle.
Upload new micro codeto the camera which
will execute on the next camera reboot cycle.
Upload new CCI to the camera which will
execute on the next camera reboot cycle.
Upload new XML to the camera which will
execute on the next camera reboot cycle.
Use UserSetSelector to specify which user set
to access.
Factory FlatField
coefficients
Use UserSetSelector to specify which user
flatfield to access.
Use UserSetSelector to specify which user FPN
to access.
Download camera information and send for
customer support.
Selects the target operation for the selected file
in the device. This operation is executed when
the File Operation Execute feature is called.
Select the Open operation - executed by
FileOperationExecute.
Select the Close operation - executed by
FileOperationExecute.
Select the Read operation - executed by
FileOperationExecute.
Select the Write operation - executed by
FileOperationExecute.
Select the Delete operation - executed by
FileOperationExecute.
Executes the operation selected by File
Operation Selector on the selected file.
Selects the access mode used to open a file on
the device.
Select READ only open mode
Select WRITE only open mode
Defines the intermediate access buffer that
allows the exchange of data between the device
file storage and the application.
Controls the mapping offset between the
device file storage and the file access buffer.
Controls the mapping length between the
device file storage and the file access buffer.
Displays the file operation execution status.
(RO).
To Next Page
Loading...
