EasyManua.ls Logo

Telemark Cryogenics 3600 - Emerson Compressor Diagnostics; Compressor Safety Warnings; Compressor Hazard Types and Precautions; CoreSense Module Fault Descriptions

Default Icon
63 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
T
4.5.1
Compressor Dia
WARNING
Failure to follo
Only qualified
permitted to ca
Use
appropria
Personal
safet
BURN HAZARD
Failure to follo
Do not touch t
ELECTRIC SHOCK
HAZARD
Failure to follo
Disconnect po
Compressor m
Electrical con
personnel.
Refer to origin
PRESSURISED SYSTEM HAZ
Failure to follo
System contai
Use only appr
Personal safet
The table below describ
CoreSense
™ module th
Green LED :
FLASHING:
Alert c
Yellow LED:
FLASHING:
Alerts o
SOLID: d
emand is p
will auto reset.
Red LED:
FLASHING:
Indicate
code. A full
system
the fault has been re
-
OCK
power
been i
Telemark Cryogenics
Microprocessor Based Cr
Page
55
of
63
Revision
iagnostics
llow these warnings could result in serious person
ied and authorised HAVC or refrigeration perso
carry out repairs and or install the compressor.
riate lifting devices to move compressors
fety equipment must be used.
llow these warnings could result in serious person
h the compressor until it has cooled down.
llow these warnings could result in serious person
power before servicing compressor.
r must be grounded.
onnections MUST be carried out by qualified
ginal
OEM electrical schematics.
AZARD
llow these warnings could result in serious person
tains refrigerant and oil under pressure.
proved refrigerants and refrigeration oils.
fety
equipment must be used.
ribes the Emerson (
Copeland
®) fault descriptions
e that monitors the operation of the compressor.
t codes that do not have a protective shutdown.
ts of abnormal compressor operating conditions.
present but no current detected. All protective
sh
ates the module (compressor) is locked out on an
m shutdown is required to rest the alarm condition
rectified.
CKED OUT ON
: codes will require the
Cryochiller
ered down to reset
the alarm condition after the f
n investigated and rectified.
Cryochillers
ion 1.0.7 October 2018
onal injury.
rsonnel are
onal injury.
onal injury.
d electrical
onal injury.
ns via
the
shutdown
any alert
ion after
ler
to be
e fault has

Related product manuals