TELES iGATE FCT User’s Guide 13
Previous Page Table of Contents Next Page
Features
This section lists the various iGATE FCT features, which
can be programmed by the user. Section 4.10, has a con-
cise summary of the programming details.
Audio Gain
Use this parameter to adjust the volume. The level can be
changed in both directions.
1. Dial ** 1343**#. The unit enters the programming
mode and emits the confirmation tone.
2. Dial *5580*#. The unit enters the 'change Rx/Tx gain'
mode and emits the confirmation tone.
3. Dial to a cellular phone and add the # sign to the end
of the phone number. (The phone number must have
at least 3 digits.) The unit emits the confirmation tone.
Wait until the call is answered.
4. Dial either:
• *70*# for Tx gain
• *71*# for Rx gain
The unit emits the confirmation tone.
5. Adjust the volume by pressing the keys on the key pad
followed by the # sign.
Note: In some units, the 2 and 8 keys are interchanged.
6. Dial 5# to save the changes.
Call Duration Limit
The duration of incoming and outgoing calls can be lim-
ited. If the call duration exceeds the limit, the call is
stopped and the user hears an error tone. To continue the
call, the user has to redial.
By default, this feature is disabled and call length is unlim-
ited.
Table 4: Audio Gain Commands
Key Result
2# Increase gain *
8# Decrease gain *
6# Apply the default settings
4# Reapply the previous settings
* Upon reaching the end of the gain scale, the
unit emits the 2-beep rejection tone.
To Next Page