TELES iGATE FCT User’s Guide 15
Previous Page Table of Contents Next Page
stores no more than 20 messages. When the inbox is full,
the unit cannot receive SMS messages and, as a conse-
quence, remote control of the unit is disabled.
1. Dial ** 1343**#. The unit enters the programming
mode and emits the confirmation tone.
2. Dial *6150*#. The unit erases all stored messages
and emits the confirmation tone.
Note: The confirmation tone can be delayed up to 30 seconds,
depending on current inbox volume.
Immediate Dialing
Use this parameter to define how many digits have to be
dialed before the iGATE FCT automatically places the
call. This feature is especially useful if the unit is installed
in a network where all the cellular phones have the same
number of digits. Setting the Immediate Dialing length to
that number of digits avoids the delay after the last digit.
Note: When the number of digits is set to the network standard—
for example, 9—shorter numbers are sent to the cellular network
after the preset delay or after pressing the # sign.
1. Dial ** 1343**#. The unit enters the programming
mode and emits the confirmation tone.
2. Dial *3210*#. The unit emits the confirmation tone.
3. Dial the number length—between 2 and 20 digits—
followed by the # sign. For example, if you dial 10#,
the iGATE FCT will place the call after 10 digits have
been dialed.
Note: To disable this feature, enter 0#.
Interdigit Timeout
The iGATE FCT collects the dialed digits and places the
call when the Inter-digit timeout period expires. The
default timeout is 3 seconds. Use this parameter to
change the default.
Note: If the “Immediate Dialing” feature is not activated, the actual
call initiation will also be delayed. To overcome this, activate the
“Immediate Dialing” feature or press the # key after the final digit.
1. Dial ** 1343**#. The unit enters the programming
mode and emits the confirmation tone.
2. Dial *3211*#. The unit emits the confirmation tone.
3. Dial the timeout length—up to 9 seconds—followed by
the # sign. For example, if you dial 5# the timeout
between dialed digits is set to 5 seconds.
To Next Page