User Manual E3
59300623 Rev.001
5.4.2018 15(20)
Establishing connection
In addition to the local user interface, the E3 amplifier can also be configured
with a PC, tablet or smartphone when E61 module is installed.
Connection to E3 is possible using the following methods:
Local configuration with a PC through E61 RIS receiver USB port
CATVisor Commander 2.10 or later and up-to-date DUS100 user interface
collection is needed for USB and Bluetooth support. These both are available
for download in Teleste extranet (MyTeleste).
Connection to E61 USB port can be done with a standard USB A plug to USB
mini B plug cable, or via AC6901 USB to Bluetooth adapter. The cable or
adapter should be disconnected when not in use to avoid possible EMC
problems caused by the cable acting as an antenna.
E61 will draw power from the USB connector for E61 and E3 microcontroller
and memory if no external power supply is available. This makes it possible to
configure E3 settings and update the software without any power supply.
Note that as only the CPU part of the unit is powered via USB, many
parameters visible via the user interface may display incorrect values. Installing
and removing plug-in modules while the unit is USB powered is not
recommended and may lead to unexpected behaviour.
Local configuration with an Android device
Teleste Commander software for Android devices can be downloaded from
Google Play. Connection to E61 USB port can be done via AC6901 USB to
Bluetooth adapter. The adapter should be disconnected when not in use to
avoid possible EMC problems caused by the adapter acting as an antenna.
Remote ingress switch control via RIS link
RIS controller module HDM155 can be used for controlling E3 ingress switch
remotely when E61 is locked to HDM155’s carrier. Remote ingress switch
control overrides local control. See HDM155 documentation for more details.
To Next Page
Loading...
