User Manual E3
59300623 Rev.001
5.4.2018 16(20)
Software update
New software versions for E3 and E61 are published at Teleste extranet
(MyTeleste). These may contain bug fixes, enhancements and completely new
features. For details see the software release history documents also available
in MyTeleste.
E3 software
E3 software can be only updated using E61 module. The E61 software includes
the E3 software image. Every time E61 software starts it checks the E3
software version. If it does not match with the version of the E3 software image
included in E61 software, the E61 automatically updates E3 software.
Ongoing E3 software update is indicated with multicolour blinking of E61’s “RIS”
led and typically takes half a minute to complete. E3 new software starts
automatically when the software update completes. If the software update is
interrupted by e.g. a power failure, E61 resumes update immediately when
power returns. Note that E3 does not have functioning software during the
software update, so short RF breaks will appear. If E61 is removed during the
software update the E3 will not have any software and does not function at all
until E61 is installed again and it completes the software update.
E61 software
E61 software can be updated locally via USB or AC6901 Bluetooth adapter
using CATVisor Commander or Teleste Android Commander. It is also possible
to update E61 software (and thus also E3 software) remotely via the RIS link.
Contact Teleste support for more details on remote software update.
The new E61 software is taken into use after it has been completely transferred
and the device is reset. This reset takes ~10 seconds after which the E61 is
fully functional and running the new software and, if needed, starts to update
the E3 software. If the E61 software update fails, E61 continues to use its
original software.
To Next Page
Loading...
